1.75mm PLA 3D Printer Filament

Rated 2.67 out of 5 based on 3 customer ratings
(3 customer reviews)

$ 19.99

1kg Spool (2.2 lbs)

SKU: N/A Category: Tags: , , , , ,


1.75mm PLA 3D Printer Filament – 1kg Spool (2.2 lbs) – Dimensional Accuracy +/- 0.05mm

Additional information

Weight 3 lbs

3 reviews for 1.75mm PLA 3D Printer Filament

  1. Rated 1 out of 5

    So I got a roll of this stuff for free for rating my printer 5 stars. The printer is with out a doubt 5 stars, but you have to take the time to fine tune it as with any other printer on the market. But this filament is straight garbage. I tried printing with it using the stock MK8/9 extruder, as well as my new E3D clone with Bowden drive, and it is impossible to print with. It is not a consistent size causing it to jam in the heat break before it gets to hot end. Very poor quality control is used on this filament, also I think it is made in China based on the sticker that came on the roll I got.

  2. Rated 5 out of 5

    This review is an update to my last review. RepRapGuru’s customer support is among the best I have seen! They sent me another roll because they were sure that I had just received a bad roll, and it turns out it was just a bad roll. This filament is on par with my favorite USA made brand, no jams, and consistent sizing. Worth trying out, get a roll or 2 if buying a printer from these guys.

  3. Rated 2 out of 5

    I would like to give this filament 5 stars however my first roll of this for some reason was very brittle and kept breaking all the time. I have never had other brands break like this did. I just purchased another roll of the same filament and hope it is better. So far so good!

Add a review

Your email address will not be published. Required fields are marked *

You may also like…